CO2氧化丙烷脱氢MoO3-V2O5/SiO2催化剂研究

采用表面改性和等体积浸渍法制备了MoO3-V2O5／SiO2复合氧化物，采用TPR、IR、TPD和微反技术表征了催化剂对CO2和C3H8的吸附性能和CO2部分氧化丙烷脱氢的反应性能．结果表明：随MoO3加入量的增加，V=O还原温度降低，晶格氧更易活化．CO2和丙烷的活化温度降低，丙烷转化率增高，丙烯选择性下降．V=O中晶格氧的活化是CO2氧化丙烷制丙烯反应的关键．     

锡—邻菲咯啉络合物吸附极谱波的研究及应用

研究了锡－邻菲咯啉体系的极谱行为，在ｐＨ＝２．５０的０．１０ｍｏｌ／Ｌ氯乙酸－氯乙酸钠介质中，在单扫描极谱上，Ｓｎ－邻菲咯啉络合物于－０．４１Ｖ电位处产生一良好的吸附还原波。波高与Ｓｎ的浓度在２．０×１０＾－８－４．０×１０＾－６ｍｏｌ／Ｌ范围内呈线性关系；检出限为１．０×１０＾－８ｍｏｌ／Ｌ Ｓｎ，对合金标样中的锡进行测定，取得了满意的结果。     

Mesoporous titanium dioxide as a novel solid-phase extraction material for flow injection micro-column preconcentration on-line coupled with ICP-OES determination of trace metals in environmental samples

Mesoporous titanium dioxide as a novel solid-phase extraction material for flow injection micro-column preconcentration on-line coupled with ICP-OES determination of trace metals (Co, Cd, Cr, Cu, Mn, Ni, V, Ce, Dy, Eu, La and Yb) in environmental samples was described. Possessing a high adsorption capacity towards the metal ions, mesoporous titanium dioxide has found to be of great potential as an adsorbent for the preconcentration of trace metal ions in samples with complicated matrix. The experimental parameters including pH, sample flow rate, volume, elution and interfering ions on the recovery of the target analytes were investigated, and the optimal experimental conditions were established. Under the optimized operating conditions, a preconcentration time of 90 s and elution time of 18 s with enrichment factor of 10 and sampling frequency of 20 h⁻¹ were obtained. The detection limits of this method for the target elements were between 0.03 and 0.36 μg L⁻¹, and the relative standard deviations (R.S.D.s) were found to be less than 6.0% (n =7, c =5 ng mL⁻¹). The proposed method was validated using a certified reference material, and has been successfully applied for the determination of the afore mentioned trace metals in natural water samples and coal fly ash with satisfactory results.     

The Mechanism on Cyclization, Debenzylation and Oxidation of 1-[1-（Benzyloxy）-3-methylnaphthalen-4-yloxy]propan-2-one

Mansonone compounds represent a series of naturally occurring o-quinones mainly isolated from the heartwood of Mansonia Altissima1 and Ulmus Glabra2. Mansonone F contained oxaphenalene skeleton which was a relatively novel structure and rarely existed in …     

Preparation and characterization of silica—polyimide composite membranes coated on porous tubes for CO2 separation

Silica-polyimide microcomposite membranes were prepared on γ-alumina-coated α-alumina support tubes, and their gas permeation properties were evaluated with He, N₂ and CO₂. Smoothing of the substrate surface and hybridization of silica and polyamic acid were both effective to form defect-free thin composite membranes. The CO₂ permeance of a membrane with a silica content of 68 wt% was one order of magnitude higher than that of a polyimide membrane having the same thickness. The permselectivity of CO₂ to N₂ was 30 at 30°C and 13 at 100°C. Contributions of the silica and polyimide phases to permeance of the composite membrane were analyzed with a two-phase permeation model. The effective thickness of the rate-controlling polyimide phase was less than one-tenth of the total thickness of the silica-polyimide membrane.     

Ruthenium-catalyzed one-pot hydroformylation of alkenes using carbon dioxide as a reactant

A new hydroformylation of alkenes using carbon dioxide as a reactant is shown to take place in the presence of ruthenium cluster complexes and halide salts. Similar or even better yields of alcohols were formed as compared to the conventional hydroformylation with CO under the same reaction conditions. The reaction proceeded in three steps: CO₂ is first converted to CO; then it is used as a reagent for hydroformylation to give aldehyde; subsequently, it is hydrogenated to alcohol. ESI-mass spectrometric analyses of the reaction solutions indicated formation of four kinds of ruthenium anionic complexes including tetra-, tri-, and mononuclear species. On the basis of experimental findings, possible roles of these complexes are discussed.     

甲烷二氧化碳介质阻挡放电转化产物分布研究

针对介质阻挡放电甲烷二氧化碳转化实验,分析了反应的产物分布,探讨了进料组成和反应器结构对反应的影响.反应产物包括:高H2/CO摩尔比的合成气、气态烃、高辛烷值的汽油组分、醇和酸等含氧有机物.对所述电极结构,产物的选择性随碳数增加而降低;高的甲烷进料浓度有利于烃的生成,对醇和酸的最佳甲烷进料体积分数范围在67.4％～75.1％;放电间隙越小,原料转化率和烃、酸的选择性越大,大的放电间隙对醇的生成有利.     

COMBINED PARTIAL OXIDATION AND CARBONDIOXIDE REFORMING OF METHANE PROCESS TO SYNTHESIS GAS

IntroductionIthasbccndcmonstratcdthatmcthancrcformingt"ithcarbondioxidcpr0ducessynthcsisgasrichincarbonmonoxidc-x"hichisuscfulforthcs}nthcsisofaccticacid'dimcthylcthcrando.o-alcoholsll'2].Carbondioxidcref0rmingismorccndothcrmicthanstcamrcformingfCH4 CO2,'2CO 2H2Ai/'2,,=2473kJ..ol-1(l)Accordingl\"thisrcact1onnccdshighcrtcmpcraturcandlimitsspaccvclocityoffccdgas,Wehavcprct'ious1\studicdmcthancrcformingt"lthC02inthcmonotubcproccssl3J.Inordertoconvcrtmcthancinfccdgascomplctcl}',thcspaccvcloci…     

Electron Probe Microanalysis of HfO2 Thin Films on Conductive and Insulating Substrates

Quantitative electron probe microanalysis of highly insulating materials is a complicated problem, partially solved by coating samples with grounded thin conductive layers or using novel scanning electron microscopy (SEM) techniques, such as low-voltage and/or variable pressure SEM. In this work, some problems of quantitative X-ray microanalysis of thin HfO₂ films, in particular the possibility to determine mass thickness correlated to the density of the layer material, are discussed. For comparison, Al₂O₃, Ta₂O₅ and TiO₂ films grown onto both semiconductive Si and insulating quartz substrates were also analysed. All the films studied were synthesized by atomic layer deposition method.     

Synthesis and properties of fluorous arenes and triaryl phosphorus compounds with branched fluoroalkyl moieties (“split pony tails”)

Most compounds designed for immobilization in fluorous media feature linear pony tails of the formula (CH₂)_m(CF₂)_n−1CF₃ [(CH₂)_mR_fn]. This paper presents a first-generation approach to compounds with branched or “split” pony tails of the formula (CH₂)_lCH[(CH₂)_mR_fn]₂. Allyl tri(n-butyl)tin is reacted twice with perfluorooctyl iodide (R_f8I; first, photochemical, 78-81%; second, thermal with radical initiator, 71%; 13-18 g scales) to give the secondary alkyl iodide ICH(CH₂R_f8)₂ (3). A subsequent Ni(Cl)₂(PPh₃)₂-catalyzed reaction with allyl tri(n-butyl)tin yields the branched alkene H₂CCHCH₂CH(CH₂R_f8)₂ (74%). A palladium-catalyzed Heck coupling with OP(p-C₆H₄Br)₃ gives the fluorous phosphine oxide OP(p-C₆H₄CHCHCH₂CH(CH₂R_f8)₂)₃ (84%), and Pd/C-catalyzed hydrogenation affords OP(p-C₆H₄(CH₂)₃CH(CH₂R_f8)₂)₃ (>99%). Reduction with SiHCl₃ gives P(p-C₆H₄(CH₂)₃CH(CH₂R_f8)₂)₃, which is protected as the air-stable borane adduct H₃B·P(p-C₆H₄(CH₂)₃CH(CH₂R_f8)₂)₃ (9, 64%). The CF₃C₆F₁₁/toluene partition coefficient of 9 is much higher than that of the analog with p-(CH₂)₃R_f8 groups (96.6:3.4 versus 37.3:62.7). The iodide 3 is unreactive towards PAr₃ at 175-250 °C. However, a CuBr-catalyzed reaction with C₆H₅MgBr gives C₆H₅CH(CH₂R_f8)₂, which also exhibits a high partition coefficient (97.9:2.1).